Non EFI, sort of.

[Eric Fahlgren]

Barry Tisdale wrote:
> 
> I'm looking for a 3"ID flexible hose, rigid enough to take some suction w/o
> collapsing.  Its to go from my turbo inlet to the air filter.  The
> corregated polyethylene hose used on shopvacs would be great, but its only 2".

Vacuum hoses are usually vinyl, I think.  They probably would melt
under the hood.  The ducting from the air box to the turbo inlet
should have very low vacuum (< 1 inch Hg), so it need not be that
rigid.

> Any suggestions as to what I might look for?

How about brake ducting?  Kinda expensive, but it would certainly
get the job done.

http://www.racerpartswholesale.com/duct.htm

--
Eric Fahlgren                            Mechanical Dynamics, Inc
efahl at adams.com                          Ann Arbor, Michigan, USA
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org