DIY-WB Output Voltage Scaling

[Bob Wooten]

I suppose you are right.  The reason I like the stamp is that you can do it
over & over & over & over again until you get it right.  I bet that a PIC
would be a more simple solution for the masses provided that someone
wanted/was able to burn a bunch of them for a bunch of people.  But that
certainly would take the DIY out of most of the project.  sure would clean
up all the little annoying things though.

LOL about the soldering comments.

BW

-----Original Message-----
From: owner-diy_efi at diy-efi.org [mailto:owner-diy_efi at diy-efi.org]On
Behalf Of Bruce
Sent: Friday, August 25, 2000 8:02 PM
To: diy_efi at diy-efi.org
Subject: Re: DIY-WB Output Voltage Scaling




FWIW,
the decison to go analog on the DIY-WB was to keep it doable for everyone.
Digitial should be an outgrowth of it, but that also takes it to the stage
of being for the few rather then the many.
  Heck look at all the comments about soldering, never mind PICs and Stamp
programming.
Bruce




From: "Bob Wooten" <r71chevy at earthlink.net>
Subject: RE: DIY-WB Output Voltage Scaling
> Peter,
> I guess that I was not paying enough attn, I did not see the curve (it did
> not occur to me to check it out).  the more that this gets developed, the
> more I think that this is a very good application for a Basic Stamp or
Basic
> X.  we have just started using them @ work & I have one here that I have
> used to turn on & off LED's.  Mind you I am not a genius when it comes to
> this stuff, but it seems that this would be a great application for this.
I
> can get small RAM's for next to nothing & DACs for a small fee.  the thing
> that cost the real money is the controller itself. the advantage here is
> that I can add in a table for linearizing it & have it do the math for me
> right down to the accuracy of the look up table itself.  We just got a
> couple of serial displays for test equipment, that were pretty cheap.
> I think that once I have my DIY WB up & running I am going to try to
emulate
> it with the stamp & see if I cant get the heater algorithms close to what
> the DIY WB is doing.  I think that once I get that fingered out the rest
is
> cake.
> Just thinking out loud.
> BW


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org