WB O2 Success

[Don DRI05 Ricciardiello]

Neil,

Congratulations, sounds great. Just a tuning question for you. How does
your bike idle? The 1.82v readout suggests it's quite rich. Perhaps it's
because of the cold ambient temp or was the choke still out at this point?

Cheers

Don





From: Neil.Poersch at mts.mb.ca@diy-efi.org on 10/12/2001 14:20 CST

Please respond to diy_efi at diy-efi.org

Sent by:  owner-diy_efi at diy-efi.org


To:   diy_efi at diy-efi.org
cc:
Subject:  WB O2 Success


<snip>........

I read 4.02V in free air with my Fluke DVM.  Drove it down to 0.79V by
flooding the sensor with propane from my plumber's torch (unlit of course).
Then installed it on my carbureted motorcycle after warming the engine up
from the ambient +3C temperature and read 1.82V at idle.........couldn't
road test it under load because of the snow drifts in the way.

<snip>...........

Thanks,
Neil



----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org