Starter Tooth Sensor Question

[bcroe at juno.com]

Good research, thanks.  Bruce Roe

On Tue, 11 Dec 2001 21:47:13 +0800 (WST) Bernd Felsche
<bernie at innovative.iinet.net.au> writes:


> Anybody who wants to try this could save themselves re-inventing the
> wheel by reading SAE Paper 1999-01-0203 "Enhanced Engine Position
> Acquisition & Treatment" by Patrick Leiteinturier and Joseph Benning
> of Siemens. It describes how to eliminate errors resulting from
> tooth geometry and other factors. 

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org