AW: Bosch peak and hold injectors

[Rausch, Bernd]

Hi Jason,

have a look at Bosch 0 280 150 363 (replacement for older 0 280 150
351). They flow 655cc/min at 3bar. They are very low impedance (0.7 Ohm)
and require 6A/1.4A current.

Best regards,
Bernd

-----Ursprüngliche Nachricht-----
Von: Jason Haines [mailto:jhaines at lingenfelter.com]
Gesendet: Mittwoch, 12. Dezember 2001 14:11
An: DIY_EFI
Betreff: Bosch peak and hold injectors


Does anyone know of any part numbers for Bosch peak-and-hold injectors?
I am
looking for injectors in the 65 to 85 lb/hr range (at 43 to 58 psi fuel
pressure).

Thanks,


Jason


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
------------------------------------------------------------------------
----
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
in the body of a message (not the subject) to
majordomo at lists.diy-efi.org


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org