WB O2 Wiring Qs

[bcroe at juno.com]

I've used unshielded cables to 8'; 15' shielded with no 
apparent problem.  Make sure the heater wire gauge is
not so small so at to have a lot of voltage drop.  You 
can check this with it running; I doubled up these wires
for the long run.

Bruce Roe

On Wed, 12 Dec 2001 02:18:34 -0800 "efi_student"
<efi.student at sbcglobal.net> writes:


> The wiring from the box to the sensor isn't specified, 
> so I am curious what lengths have been tested and 
> since I am building a few, I figure it would be best to
> get something on a decent sized roll to save expenses.  
> Would a sheathed 8 conductor 18 ga about 15' long 
> with Beldfoil (or equivalent) be too much?  Is anyone 
> having noise issues?  Is this an experiment and
> report back to the list item (that's fine, I'll do it, just don't 
> want to reinvent the wheel here)?
> 
> Lance

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org