Starter Teeth Sensor

[skulte]

There were one or two technical sessions exactly about this at last years
(2001) SAE World Congress. The Technical Reports should be available off
the http://www.sae.org website for $10 non members and $8 members. It will
probably shave some time off development if ya decide to retire and go for
it! ;)

Andris Skulte
Z28tt-89 IROC T56 DFI Twin Turbo

On Thu, 13 Dec 2001 bcroe at juno.com wrote:

> I also have thought for a long time, that differentiating
> the velocity of teeth moving by would be a good way to
> see the relative power output of each cylinder, with the
> right dispay.  Another project for retirement.
> 
> Bruce Roe
> 
> On Wed, 12 Dec 2001 13:53:21 -0800 (PST) James Montebello
> <jamesm at lapuwali.com> writes:
> 
> > Watching many teeth also gives you the ability to watch 
> > the rate of change of the crank speed more closely, and 
> > potentially divine things like misfires (which should show
> > up as two anomolously large changes in crank speed 
> > during one or two revolutions) for very sophisticated 
> > control strategies.  
>  
> > james montebello
> > 
> > On Tue, 11 Dec 2001, Orin wrote:
> > 
> > > > Bernd Felsche wrote:
> > > > > 
> > > > > You mean the starter drive teeth on the flywheel for timing?
> 
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> 

------------------
Andris Skulte
Skulte Performance Designs
http://www.skulte.com  
Z28tt-89 IROC T56 DFI Twin Turbo

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org