Home for an injector

WEG1192 at aol.com WEG1192 at aol.com
Mon Dec 17 07:11:05 GMT 2001


In a message dated 12/15/01 10:26:30 PM Eastern Standard Time, 
dave.williams at chaos.lrk.ar.us writes:

> BDS cuts screw threads on each end of the injector and screws them
>  directly into the intake, then screws a hose fitting on the other end.
>  
I'm doing this but I didn't speak up because you asked what kind of success 
and its the first time I've tried it. Mainly saves a ton of precise 
machining. If you mar up the hole when drilling for an O-ring, you're SOL. If 
you mar up the hole when drilling for a threaded injector, a tap will take 
care of it. I saved about 20 hours of work from this trick. Now the task is 
to build a separate fitting for each injector and figure out a way to hold 
them on the injector. Got an idea but haven't finished machining.

JW

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org




More information about the Diy_efi mailing list