WBO2 testing

Neil.Poersch at mts.mb.ca Neil.Poersch at mts.mb.ca
Thu Dec 20 02:39:41 GMT 2001


I added two 15 ohm resistors in parallel with the 1 ohm resistor on my
unit.  The current went from 1.2 to 1.4A and the warm-up time dropped from
4 minutes to 45 seconds.  Perfect.

Neil


>
Sounds like you need some of the 15 ohm resistors across R4.
The current should be ~1.4A max. And yes the VR does run
hot and needs a bit of heat sink.
<


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org



More information about the Diy_efi mailing list