Maximum Piston Speed

[elcamino73]

That's were I got hooked on this type of set up.
Talking to Speedomotive about the bottem end.
August over there want's to keep the stroke the same.
I'm paying so, We're doing it my way.
My AFR heads and roller cam should flow well under 14PSI of boost!
Projecting 600-700 HP...

----- Original Message -----
From: "The Dupuis" <dupuis10 at telusplanet.net>
To: <diy_efi at diy-efi.org>
Sent: Thursday, December 20, 2001 7:31 PM
Subject: RE: Maximum Piston Speed


> Brutal Snippage...
>
> >  I'm currently in the middle of destroking my 400 with a 3.48 crank and
6
> > inch rods.
> > And then supercharging the set up.
> > Minimizing cylinder side loading is what I'm after, The extra bore and
air
> > flow appeals to me as well.
>
> Have a look at Hot Rod June '97:  400 block bored .030, 307/327 crank,
Ford
> 300 I-6 rods (6.209"), JE pistons, Air Flow Research 305- style heads,
> 215/215 @.050" Comp camshaft, 11:1 C/R, 87 octane fuel, 412.3 hp @5700 and
> 435.0 ft-lbs @3800, with 390 ft-lbs from 2400 to 5400 rpm.  350 cubes,
very
> little side loading, incredible torque curve (?, seems pretty flat to
me)...
> This could be my favourite engine, if only I were a chev guy.
>
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org