Maximum Piston Speed

[Greg Hermann]

At 5:54 PM 12/20/01, The Dupuis wrote:
>Brutal Snippage...
>
>>  I'm currently in the middle of destroking my 400 with a 3.48 crank and 6
>> inch rods.
>> And then supercharging the set up.
>> Minimizing cylinder side loading is what I'm after, The extra bore and air
>> flow appeals to me as well.
>
>Have a look at Hot Rod June '97:  400 block bored .030, 307/327 crank,

Same bore and stroke (4-1/8" x 3-1/4") as the old Chubby 348 fat blocks
had. Hmmmmm.

Greg

>This could be my favourite engine, if only I were a chev guy.
>
>----- End of forwarded message from owner-diy_efi at diy-efi.org -----
>----------------------------------------------------------------------------
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org