Where can I get ignition map sample ?

[RD1林台生]

I use S1 hall effect sensor to pick up crank position.
And it works fine.

(Hall effect sensor Output)
Vcc-12V
Gnd - ECU ground
Home(one piece) - 6~7 V (When hall effect sensor meet south megnet.)
Trigger(three pieces) - 6~7 V(When hall effect sensor meet north megnet.)
Above data is measued when engine stop.

So, I should ajdust my advanced BTDC under 20d (estimated) in Haltech E6K
ignition Map when boost 15~20 PSI ?
Is there good denotation monitors(wrong spelling??) for import cars ?

Forgive my poor English again.

Best regards,
Tyson.

-----Original Message-----
From: James Ballenger [mailto:vtjballeng at yifan.net]
Sent: Monday, January 15, 2001 5:12 PM
To: 'diy_efi at diy-efi.org'
Subject: RE: Where can I get ignition map sample ?


	As was pointed out, this is extremely engine dependant.  For a 600cc
Honda F3 engine, it will apparently take 30-37 degrees above 4000 rpm under
full (7psi) boost but this was for a restricted engine.  Were you getting a
good steady signal for ignition?

James Ballenger

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org