[OT]Electronic Cams? EDN article Link

[Shirley, Mark R]

This is solenoid based valve timing.  It's one of the primary reasons for
the OEM's going to 42V electrical systems.  We're a ways away from that 
at this point though.  Just think of the controller needed....

-----Original Message-----
From: Terry_Sare at Dell.com [mailto:Terry_Sare at Dell.com]
Sent: Monday, January 22, 2001 11:11 AM
To: diy_efi at diy-efi.org
Subject: [OT]Electronic Cams? EDN article Link


A little off topic but interesting. May have to register to get to article.

ts

5. ELECTRONICS MAY BE POISED TO DISPLACE ENGINE CAMS
Software-based control may replace mechanical cams that control internal 
combustion-engine valves, but potential roadblocks remain.
http://www.ednmag.com/ednmag/reg/2001/01182001/02hiw.htm 
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org