MAP Sensor.

[Walter Sherwin]

Thanks.....




> Hi,
>
> It's a sensor specifically designed for Turbo'd applications.  If you take
> apart an older Haltech you'll see it's earlier predecessor like an MPX2100
> or some variant.  This particular one is temperature calibrated over the
> Industrial temperature range.  I used the MPX2100 for Ambient pressure but
a
> new design will now use these as they are compensated much better.
>
> It's by no means ready to go as a bolt it inside the engine compartment
but
> more a device meant for a roll your own processor based system.
>
> Cheers,
>
> John Dammeyer
>
>
>
> > What is this sensor?  Range?  Same connector hook-up?  Any notable
> benefits
> > beyond the OE GM MAP's?  Do you use this sensor? Would be curious to
know
> > more about it.......
> >
> > Walt.
> >
> >
> >
> > > Hi all,
> > >
> > > Any reason no one has mentioned the Motorola MPX4250A series as a
> suitable
> > > MAP sensor for Turbo'd applications?
> > >
> > > Regards,
> > >
> > > John Dammeyer
> > >
> > >


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org