TBI Manifold Preference...???
Shannen Durphey
shannen at grolen.com
Sun May 27 05:38:25 GMT 2001
The Punisher wrote:
>
<snip>
> I applied thermal barrier coating on the piston tops,combustion chambers,
> valve's, and exhaust ports. I air-brushed it on after SAND-blasting(NOT
> glassbead), then cured it in the oven.
Acid etching works very well. Prep and cleanup times are
significantly reduced. Hydroflouric wheel acid is strong
enough to etch stainless valves as well as everything else
you may choose to coat.
Shannen
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org
More information about the Diy_efi
mailing list