DIY_EFI Digest V5 #879

[Ron Schroeder]

Thanks for the reply Bruce (and your off-list one too).
This means that I CAN use the NA MAP (MPX4115AP) with 2 pounds of boost on
my engine.  I want to run more boost at higher altitudes (about 5 pounds at
10,000ft.) to keep sea-level performance.

Thanks,
Ron

At 08:10 AM 11/14/01 -0500, you wrote:
>My error on the part numbers - the MPX4100 is *almost* the same thing as 
>the MPX4115, but an older part with a slightly different range, and it is 
>harder to acquire.
>
>The MAP sensors, full part numbers, are MPX4115AP (115 KPa) and MPX4250AP 
>(250 KPa) - the "A" means absolute pressure and the "P" means a barbed port.
>
>Sorry for the MAP number confusion - my typing fingers are not the best at 
>times.
>
>- Bruce


Ron Schroeder
WD8CDH
E. E. S.
wd8cdh at bnl.gov
rjs at bnl.gov
ron at 112motors.com
631 344-4561 Day
631 286-5677 Nite

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org