wb-o2 calibration?

[rr]

The calibration is included with the sensor. A resistor
in the sensor connector is used. Just be sure to wire it
into the CalR location of the circuit.

Free air will be ~4.0 Vout.

BobR.

On Fri, 19 Oct 2001 08:38:13 -0700
 Andrew Theurer <habanero at us.ibm.com> wrote:
> I was going through the docs on the ftp site, I can't
> find any reference to 
> calibrating the ntk sensor for the diy board.  I thought
> each sensor was 
> slightly different, and at least a free air calibration
> was required.  How is 
> the sensor calibrated?  
> 
> Thanks,
> 
> Andrew
> 
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org