Source for high pressure 12v water pump

[Joseph Obernberger]

Mark Chauvin wrote:

> Dave,
>
> Any idea where you would get a tank for that setup?  A small air
> reservoir from Sears would work I guess, but how would you put the
> water in?  And how would you make sure just water goes out, and not
> air (bubbles)?  I saw a web site where a guy used a tank with a
> bladder, but it looked very tedious to refill it.

That would be me...  It is somewhat tedeous to fill - as I still currently gravity fill
it...but one could use a low pressure water pump to do it.  I think Bruce's idea about two
tanks is very interesting!
<http://josepho.www4.50megs.com/WI>  One nice thing about the tank setup is that making
more 'stages' to the system just involves adding another solenoid and pressure switch.
Good luck!  BTW - with the bladder setup, the bubbles rise to the top - so, if the tahk
remains upright and relatively full, bubbles shouldn't be too much of an issue - the lines
from the solenoids to the injectors need to be kept as short as possible, however.

                                                    joeo


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org