6 wire O2 sensor?

[Bernd Felsche]

Shannen Durphey tapped away at the keyboard with:

> Jack wrote:
> > 
> > It's a Bosch LSU 4. part no. 0 258 006 066 (or 065)
> > It's got 5 wires going to the sensor from the plug and 6 wires from the plug
> > to the controller.
> > There is some electrical stuff in the plug, I never looked at it closely.
> > maybe it's the cal resistor? I don't know.

> Small bit of film in there, connected between 2 terminals (which
> accounts for 6 in the connector).  It is marked very obviously
> with + and -, so I'd hazard that it's not a *regular* resistor.

Any pin-outs/wire colours known for heater, pump and Nernst cells?

We _can_ get these sensors in Australia. About AUD$300 + GST retail IIRC.

-- 
 /"\  Bernd Felsche - Innovative Reckoning, Perth, Western Australia
 \ /      ASCII ribbon campaign | I'm a .signature virus!       |
  X       against HTML mail     | Copy me into your ~/.signature|
 / \      and postings          | to help me spread!            |
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org