DIY-WB construction question

[Brian Renegar]

>J9 & J10 are the cal resistor. You can run wire out to the plug on the
>sensor where the cal resistor is located or measure it and place a like
>resistor across J9 & J10. I'm running the wire out and back. Mark


Ok, I guess I don't know how the sensor is set up then.  I thought that the 
cal resistor was wired within the 5 wires on the connector.  Is that not 
the case?

Brian

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org