DIY-WB construction question

[Mark S. Riley]

The plug on the sensor is actually an 8 pin unit. 5 are used for the heater
and sensor, 1 is blanked off, and the last 2 are where the cal resistor is
located. It works. Mark
----- Original Message -----
From: "Brian Renegar" <thomas.renegar at nist.gov>
To: <diy_efi at diy-efi.org>
Sent: Sunday, September 02, 2001 7:03 PM
Subject: Re: DIY-WB construction question


>
> >J9 & J10 are the cal resistor. You can run wire out to the plug on the
> >sensor where the cal resistor is located or measure it and place a like
> >resistor across J9 & J10. I'm running the wire out and back. Mark
>
>
> Ok, I guess I don't know how the sensor is set up then.  I thought that
the
> cal resistor was wired within the 5 wires on the connector.  Is that not
> the case?
>
> Brian
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org