Modifying/fabricating manifold for injectors?

[Alan Barrow]

Eric writes:

> Get some injector cups off an engine that was originally equipped with
K-jet
> (I'm familiar with VW and Audi stuff, but there are lots more, Volvo and
Porsche
> come to mind).  These are threaded, something like 21x1.5, on the outside
so you
> just need to weld threaded bungs to your manifold, screw in the cups and
pop in
> the injectors.

Great info! I had pulled injectors before, but never realized they had screw
in cups!

I had wondered how they machined the grove the O-ring seats in. Using a cup
makes lot's of sense. Between the cup idea, and something I read elsewhere
about using a brass compression to 3/8" pipe thread fitting I should be able
to cobble something up.

Thanks!

Alan

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org