4.4 amp or 2.4 amp peak and hold injectors

[ECMnut at aol.com]

In a message dated 9/27/2001 9:09:38 AM Eastern Daylight Time, 
jhaines at lingenfelter.com writes:

> Does anyone know which type of peak and hold injector is more common - the
>  4.4 amp or the 2.4 amp? Any functional differences between the two (other
>  than the current load)?
>  
Jason,
I seem to remember reading in the archive that the 2.4 amp units
are port applications, and 4.4 were TBI.  There are prolly a few exceptions.
Anyone else remember this?
Mike V
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org