4.4 amp or 2.4 amp peak and hold injectors

[Bruce]

From: <ECMnut at aol.com>
Subject: Re: 4.4 amp or 2.4 amp peak and hold injectors
> jhaines at lingenfelter.com writes:
> > Does anyone know which type of peak and hold injector is more common -
the
> >  4.4 amp or the 2.4 amp? Any functional differences between the two
(other
> >  than the current load)?
> Jason,
> I seem to remember reading in the archive that the 2.4 amp units
> are port applications, and 4.4 were TBI.  There are prolly a few
exceptions.
> Anyone else remember this?
> Mike V

2.4 for 2.4 ohm types.
and 4.4 for 1.2 types.
Same as you mention
Bruce

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org