No Subject

[Terry Frankcombe]

Hi folks

While this is an EFI list, my searches have shown up substantial discussions 
on transmission control here in the past.  So here's an electronic 
transmission control question.  (If you can suggest a better list to post this 
to, please do!)

We have a 4L80E transmission that we're tying to fit onto a diesel V8 in a 
Landcruiser.  These beasts aren't common in Australia, so we are having 
difficulty getting any documentation.  The problem we have is that the wiring 
loom we have to connect to the ECM has a PED1 plug on the transmission end, 
whereas the transmission takes a PED2 plug.  (I think we have a miss-match in 
the years of the controller and gearbox.)  Does anyone have a wiring diagram 
for the connection?

The relevant numbers are:
Gearbox: hydromatic 4L80E, No. 13BMP6, previously factory fit to a 6.2L V8 
Chev diesel.
ECM: #16147609

Ciao
Terry

-- 
Terry Frankcombe
Computational Molecular Science Group
Department of Chemistry, University of Queensland, Australia
Ph (07) 3365 3732    T.Frankcombe at chemistry.uq.edu.au
<http://www.chemistry.uq.edu.au/homepages/crdgroup/frankcombe.html>


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org