UEGO

[rr]

I think that this is what you are looking for. Note that the AFR
is measured at J8 Vout, referenced to true ground.

DIY-WB PCB connections.

UEGO Controller Connections:

        J11:    Power in (12v to 16v)
        J12:    Ground in

        J5:     Vs, To sensor connector red
        J6:     Ip, To sensor connector white
        J7:     Vs/Ip Gnd, To sensor connector black

        J9:     CalR, To sensor connector
        J10:    CalR, To sensor connector

        J8:     AFR voltage value output, Referenced to ground (J12)
                (see Vout.txt for Vout to AFR conversion)


Heater Controller Connections:

        J3:     Power in (13v to 16v)
        J4:     Ground in

        J1:     +V to sensor heater connector orange
        J2:     -V to sensor heater connector yellow


BobR.


Interprep wrote:

>    Part 1.1       Type: Plain Text (text/plain)
>               Encoding: quoted-printable

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org