Is BP Sensor needed in MAF system???

[Perry Harrington]

The EEC-IV uses a BP sensor.  These are used in almost every MAF system.
The Ford one is a 3 x 2 inch box that usually lives on the firewall.

It's there, any decent wiring diagram will show it.

--Perry

On Sun, Apr 07, 2002 at 05:41:08PM -0400, Ron Boley wrote:
> Perry/Les,
> 
> Can you tell me if a MAF based solution precludes the need for a barometric
> pressure transducer?  I have an EEC-IV system that I've been through and I
> don't see an input nor an internal (EEC-IV) BP sensor.
> 
> Thanks

-- 
Perry Harrington             Linux rules all OSes.               APSoft      ()
perry at apsoft dot com 			                 Think Blue. /\

Those who would give up essential liberty to purchase a little temporary safety
deserve neither liberty or safety. Nor, are they likely to end up with either.
                             -- Benjamin Franklin

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org