[Diy_efi] CIS EFI via Fuel Pump PWM

[bcroe at juno.com]

Do you have a drawing for that simple 30 amp 20 volt boost 
regulator?  Thats 600 watts out, at 85 % efficiency over 700 
watts in.  Thats 59 amps off a 12 volt source, a fair hunk of 
current.

Bruce Roe

On Wed, 7 Aug 2002 12:16:37 -0500 Marc Reviel 
<marc at powerlogix.com> writes:

>  I would consider paralleling two small, low(est)-inertia pumps. 
> Plus, run them from higher than batt voltage (simple ~30 amp 
> ~20V boost regulator).  Never need to exceed 12V RMS for more
> than 1/10 sec or so

> Marc Reviel

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi