[Diy_efi] LM2902 which one to use

[rr]

The NatSemi you show is the correct device. Checking my 
DigiKey cat they did change the part number. Most likely
the TI part is also correct.

BobR.

P.S. looks like DigiKey added a bunch of new TI stuff.

"Martin, Sam" wrote:
> 
> I'm still building the DIY WB controller. I know almost nothing about
> digital electronics (just what I've managed to read in the past week in very
> basic Radio Shack books).
> 
> Anyway, the parts list specifies two LM2902N-ND chips. Digikey does not show
> this part number. However, they have two chips that appear to be similar:
> LM2902NNS-ND "IC OP AMP QUAD LOW POWER 14-DIP" mfg part # LM2902N (National
> Semiconductor)
> 296-6599-5-ND "IC QUAD OP AMP 14 DIP" mfg part # LM2902N (Texas Instruments)
> 
> I've ordered two each of these and was wondering if either would work and
> which would be my best choice (if it matters)?
> 
> Thanks,
>         Sam
> 
> Sam A. Martin
> Statistician
> Innovative Emergency Management
> http://www.ieminc.com
> 8555 United Plaza Blvd. Suite 100 Baton Rouge, La 70809
> (225) 952-8230 [voice]
> (225) 952-8122 [fax]
>

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi