[Diy_efi] WB psychosis
rr
rrauscher at nni.com
Fri Aug 30 19:07:52 GMT 2002
On Fri, 30 Aug 2002 06:37:49 -0700
"Jeff Feltman" <jfeltman at intrnet.net> wrote:
> Help Me Please
>
> I have built two DIY_WB kits and went through all the
> test procedures and got absolutely flawless compliance
> with the standards except the LED comes on immediately..
The heater ready light should take 5 to 10 seconds to
illuminate. So this does not look correct.
> . . .and as long as the sensor remains UNCONNECTED
> everything works right according to procedures. I have
> checked the test numbers both using the solder points and
> the pinouts at the connector (just to make sure that I
> hadn't stupidly miswired something). BOTH UNITS ACT
> IDENTICALLY. BTW I am using a portable battery booster
> (the yellow thing) as a power source and it puts out over
> 13.0 v. As soon I connect the sensor, the LED goes out
> and the heater stays COLD forever. When I measure the
> voltage through the power leads I get .013 volts and I am
Even if the power voltage in was low the heater controller
would still produce an output voltage. Double check the
orientation of the LT1086.
BobR.
> completely confused. The first sensor I bought was used
> so I have already bought a second sensor and it acted
> identically to the used one.
>
> Will someone please try to help. I am on my last nerve.
>
> Thanks
> Jeff
---------------------------------------------------------------------
Web mail provided by NuNet, Inc. The Premier National provider.
http://www.nni.com/
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list