[Diy_efi] RE: Diy_efi digest, Vol 1 #401 - 12 msgs

[Patrick Cahill]

Message: 9
Date: Thu, 12 Dec 2002 01:50:54 -0800 (PST)
From: Matt Rogge <rogue555 at yahoo.com>
To: diy_efi at diy-efi.org
Subject: [Diy_efi] [Newbie] Briggs EFI fuel pump
Reply-To: diy_efi at diy-efi.org

--0-676899925-1039686654=:74039
Content-Type: text/plain; charset=us-ascii


I'm starting work on a class project to use efi on a 3.5 HP Briggs single
cylinder engine in the hopes of large fuel efficiency. We're looking for an
appropriate output/pressure pump, hopefully a nice small one. Anyone know of
a supplier for such a part?

Any help is greatly appreciated,

Matthew Rogge

http://smv.berkeley.edu


Matt Rogge
rogue555 at yahoo.com


I'm assuming you will need about 40-60psi of pressure. In which case, Delco
make a couple of small in tank rollercell type high pressure pumps that are
quite common and cheap. Try Delco EP254. It'll flow heaps more than you need
but if you set it up with a return type pressure reg. it should work fine.


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi