[Diy_efi] RE: Timing and dyno pulls

[A6intruder]

Josh,

That's a relief, I didn't mean to make light of your problems.  I have
recently had the great honor of replacing 8 exhaust valves due to my
inexperience with cam timing.  Now I know how to do it right but those
teardowns are a lot of time and money.

Good luck on your project.

Daniel R. Nicoson
Equipment Exchange Company
Phone:  (814) 774-0888
Fax:      (814) 774-0880

-----Original Message-----
From: diy_efi-admin at diy-efi.org [mailto:diy_efi-admin at diy-efi.org]On Behalf
Of Joshua Wingell
Sent: Thursday, December 19, 2002 2:37 PM
To: diy_efi at diy-efi.org; diy_efi at diy-efi.org
Subject: Re: [Diy_efi] RE: Timing and dyno pulls

On Thu, 19 Dec 2002 14:01:39 -0500
  "A6intruder" <A6intruder at adelphia.net> wrote:
> I never heard much
>after reading that
>article but the think supposedly ran great, like your
>melt-down Eclipse but
>longer.

I should mention that I didn't melt anything. :)  The
block was fine, the pistons were fine, so was the head.
 But I had 73psi compression in cylinder 4 due to the head
gasket. :)

Josh

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi