DIY Gear Sensor

[huw scourfield]

Switches may be simple, but will they be reliable? A similar system could be
made from some reed relays on the link rod, two on the for/aft, 3 for the
rotational element of the same rod. With some simple logic this should be
reliable?
    Huw
----- Original Message -----
From: "bob" <bob at scientist.com>
To: <diy_efi at diy-efi.org>
Sent: Thursday, February 14, 2002 4:22 AM
Subject: DIY Gear Sensor


> Does anyone have any ideas on making a manual transmission
> gear select sensor ?
>
> The simplest thing i can think of is designing some bracketry
> to attach to the shifter base with a set of limit switches?
>
> Are there any switches / vendors you would recommend?
>
> Thank you.
>
>
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org