Quick question Re: J9 & J10...

[bcroe at juno.com]

J11 connects to battery power; straight to J3 in most applications.
J12 connects to ground, to J4 in most aps.
Meter goes to J8 and J12.
J9 and J10 go to the sensor, to the 2 pins having no provision 
for wires.  There is a cal resistor inside that connector.

Do the electrical pre tests before hooking up that expensive
sensor.

Bruce Roe

On Thu, 21 Feb 2002 21:05:46 -0500 "TROYXTROY" <TROYXTROY at cox.net>
writes:
> Quick question.
> What do I connect to the J9 & J10 contacts on the DIYWB board???
> Also, J11 & J12 are what I connect my DVM to, right?
> Thanks
> -Troy
> (Can't believe I'm almost finished!  Man I hope this thing works for 
> me!!!)
> 
>
-------------------------------------------------------------------------
---
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the 
> quotes)
> in the body of a message (not the subject) to 
> majordomo at lists.diy-efi.org

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org