Quick question Re: J9 & J10...

[rr]

Troy,

J9 & J10 are wired to the cal resistor within the sensor
connector. They are the pins with no wires to sensor.

J3 & J4 along with J11 & J12 get B+/GND, power in.

J8 & J12 (gnd) go to your meter for reading AFR Vout.

J1 & J4 go to sensor heater (via sensor connector)

J5, J6 & J7 go to sensor (via sensor connector)

BobR.


TROYXTROY wrote:

> Quick question.
> What do I connect to the J9 & J10 contacts on the DIYWB board???
> Also, J11 & J12 are what I connect my DVM to, right?
> Thanks
> -Troy
> (Can't believe I'm almost finished!  Man I hope this thing works for me!!!)
>

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org