[Diy_efi] Q regarding placement of a pressure sensor
Shannen Durphey
shannen at grolen.com
Tue Jul 16 00:24:01 GMT 2002
There are units designed to replace the VAF with a MAP and IAT pair. The
HKS VPC (recently discontinued) comes to mind. It outputs a frequency
signal based on air density which is similar to the VAF signal.
Shannen
steve ravet wrote:
>
> Bob Moon wrote:
> > I am thinking about converting from the MAF to a MAP
> > sensor arrangement. Typically, the MAP is routed to
>
> You can't replace a MAF with just a MAP. You need some estimation of VE
> in order to calculate MAF from MAP. GM ECMs use a table indexed with
> both MAP and RPM. You could also use throttle position plus MAP (less
> accurate).
>
> --steve
>
> --
> Steve Ravet
> steve.ravet at arm.com
> ARM,Inc.
> www.arm.com
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list