[Diy_efi] 749 code in 730 ecm

[Bruce]

A 730 is designed to run 8 saturated, or 1 TBI Peak and hold.
It would ****seem**** logical that you could run two TPI P+Hs on it.
Saturated ie ~18 ohms
TBI Peak and Hold ~ 1.2
TPI Peak and Hold ~ 2.4

A 749 is designed to run 6 saturated, but folks have run 8 without problems.
Or 4 TPI Peak and Holds.
Or again by extension, 2 TBI Peak and Holds.

Bruce



----- Original Message -----
From: <Djfreggens at aol.com>
To: <diy_efi at diy-efi.org>
Sent: Monday, July 22, 2002 4:38 PM
Subject: Re: [Diy_efi] 749 code in 730 ecm


> in the event that i cant locate an ecm i can use the 7730 but using it for
> p/h injectors seems a bit risky. ill get somemore detials of the engine i
am
> going to be placing it on tonight then post individual impednce and such
so
> you guys can help me make an informed decision.
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi