PC Board for WB02 36 LED bar graph display

[bcroe at juno.com]

The bare PC boards for the WB 36 LED bar graph 
display seem to be fine.  These use the parts list from 
the diy web site, not included.  I like connectors, so the 
board will accept a PC 15 pin male D-Sub connector;
I'd recommend a right angle type like
AMP 747841-4, Dig*Key part no  A23281-ND, $2.13.  
Don't forget a mate for your cable, and a heat sink 
for the voltage regulator.

Maybe someone who gets one working can throw a 
picture up for us.  

I have about 30 of these to spare; I can slip one in an 
envelope to USA address, with documentation, if you 
send me $15.  I can get more later; price might vary.

Bruce Roe
2375 Parkview Av
Aurora, IL 60504-9779

On Sat, 2 Mar 2002 12:40:26 -0600 bcroe at juno.com writes:
> I am expecting several dozen PC boards for the WB LED 
> display, middle of next week.  After I test a couple, the rest
> of the bare boards will become available.  

>  A few parts have been swapped around to optimize 
> small size, looks like 2.2" x 4.3".  

> Bruce Roe

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org