Sheilding on Diy-WB connector wires

[Hugh Keir]

I am finishing off the wiring on my WB circuit board using connectors from a
scrapyard.

I noticed that the calibration resistor wires and the yellow -ve heater wire
are wound round each other as a twisted triple and have a copper braid
sheath outside them and then a protective rubbery sheath to keep them all
together.

This suggests to me that there might be a shielding issue either with the
standard Honda wiring, or more importantly there may an issue in general and
these three wires should be separated from the others in all our set-ups.

Hugh



----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org