Fw: [Diy_efi] compression ratio

[Bruce]

In some US applications the external Bosch EFI Port Pumps, have an all
stainless construction.  And why use injectors?.  A simple .016" ish orfice
should get you by for starters.  Do a complete installation, and measure the
actual delivered fluid to see where you are, a little alky to keep it from
freezing in cold weather might be needed, and depending on cal, might not
really need the WI in real cold weather anyway.
Bruce

----- Original Message -----
From: "William Shurvinton" <shurvinton at orange.net>
To: <Diy_efi at diy-efi.org>
Sent: Thursday, May 09, 2002 6:11 PM
Subject: Re: Fw: [Diy_efi] compression ratio


> It's the tribology I'm more worried about. What do you mix with the water
to
> prevent killing pump and injector in short sequence?
>
> That and the fact that I'd be water injecting a NA rotary, which I suspect
> would be a first and I am still somewhere between 'lethal' and 'dangerous'
> on the learning scale. Would be very interesting to try though, especially
> since I found a good supply of bosch pump/swirl tanks cheap. All the
wrecks
> from Londons motorways are taken to a 40acre junk yard. You get about a
week
> to strip em out and then they're crushed. The yard makes its money from
the
> metal so charges peanuts for the parts you pull. Life can be good
sometimes
> :-)
> ----- Original Message -----
> From: Bruce <nacelp at bright.net>
> To: <Diy_efi at diy-efi.org>
> Sent: Thursday, May 09, 1996 10:28 PM
> Subject: Re: Fw: [Diy_efi] compression ratio
>
>
> >
> > Feature creep gets that way. <g>
> > 339, can perform enough logic and a Bosch pump the pressure.
> > Bruce
> >
> > ----- Original Message -----
> > From: "William Shurvinton" <shurvinton at orange.net>
> > Subject: Re: Fw: [Diy_efi] compression ratio
> > > Now that is very interesting.......Shame aquamist stuff is so
expensive.
> > > You're gunna give me bad dreams again :-)
> > > Bill
> >
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi