[Diy_efi] WB free air calibration

[rob files]

Hi all,

After replacing some blown out parts, I got my diy-WB sensor working last 
night.  Thanks to all the REAL contributors to the project.

My free air reading is something like 3.91V.  I was wondering, does this 
mean all of my readings will be offset by 0.09 volts?  I was thinking about 
adding a trim pot to the calibration resistor and adjusting Vout to be the 
4.0V free air value.  Any reason why this would be a bad idea?

thank again,
Rob

_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp.


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi