[Diy_efi] tach sensing
Dan D'Andrea
dan_dandrea at hotmail.com
Mon Nov 4 18:37:51 GMT 2002
My guess would be that RPM is calculated by the DIS module since it is
reading a sensor attached to the crank. I would assume that tachometers in
DIS systems are connected directly the DIS module.
--Dan D'Andrea
From: "William Shurvinton" <shurvinton at orange.net>
>Reply-To: diy_efi at diy-efi.org
>To: <diy_efi at diy-efi.org>
>Subject: Re: [Diy_efi] tach sensing
>Date: Sat, 2 Nov 2002 20:32:55 -0000
>
>Usually the DIS pack handles all that.
>----- Original Message -----
From: "bob limo" <fatbillybob at yahoo.com>
>To: <diy_efi at diy-efi.org>
>Sent: Saturday, November 02, 2002 6:15 AM
>Subject: [Diy_efi] tach sensing
>
>
> > Hi Guys,
> >
> > How are tachs sensed on tyipical DIS systems
>
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>http://www.diy-efi.org/mailman/listinfo/diy_efi
_________________________________________________________________
Broadband? Dial-up? Get reliable MSN Internet Access.
http://resourcecenter.msn.com/access/plans/default.asp
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list