[Diy_efi] Re: Diy_efi digest, Vol 1 #343 - 8 msgs

[Mike]

depends on how exposed it is to environemnt, some resistor
manufacured chemicals (non metal films) are slightly hygroscopic,

but most bosch mafs are well sealed in that gel stuff,

rgds

mike


At 11:36 AM 6/11/2002 -0800, you wrote:
>--- Bill Washington <bill.washington at nec.com.au>
>wrote:
>
>> I would be more concerned about aging of the other
>> resistors in the bridge because they will affect the
>> static balance current, therefore the temperature of
>> the hot wire, therefore the degree of cooling any
>> given airflow causes, and therefore the current
>> change to balance it out and the current change is
>> what is used to determine the airflow!
>
>> Any comments?
>
>I hadn't thought of that.  :D
>
>Yeah, I would be more concerned in the same manner. 
>Although at what age would you become worried about
>component drift in something like a resistor?
>
>=====
>| Adam Wade                       1990 Kwak Zephyr 550 (Daphne) |
>|   http://y42.photos.yahoo.com/bc/espresso_doppio/lst?.dir=/   |
>| "It was like an emergency ward after a great catastrophe; it  |
>|   didn't matter what race or class the victims belonged to.   |
>|  They were all given the same miracle drug, which was coffee. |
>|   The catastrophe in this case, of course, was that the sun   |
>|     had come up again."                    -Kurt Vonnegut     |
>
>__________________________________________________
>Do you Yahoo!?
>HotJobs - Search new jobs daily now
>http://hotjobs.yahoo.com/
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>http://www.diy-efi.org/mailman/listinfo/diy_efi
>
>

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi