[Diy_efi] W-B question

[bcroe at juno.com]

Check the WB on a regulated 14V supply, and it should be 
steady.  You must have enough heat sink on the heater reg 
U1 to keep it from shutting down.

If the voltage from your power connection is less than you 
see at the alternator output stud and case, try powering it 
with a pair direct from there.

Bruce Roe

On Wed, 16 Oct 2002 14:38:28 -0700 "Don Maloney" 
<dpaul at shasta.com> writes:
>  I have my recently completed W-B unit  installed in the car. 
> My question is about the LED. It will not come on just with 
> battery voltage until I start the car and then after about 20 
> seconds it comes on and is bright for about 2-3 minutes, 
> then it starts flashing for another 2-3 minutes and then it 
> goes dim but stays on. Is this normal ? 

> Don

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi