[Diy_efi] Bosch DME trouble...

[Adam Wade]

--- Mike Sharp <Mike_Sharp at pacbell.net> wrote:

> With the harness  disconnected at both the airflow
> sensor and the Motronic the resistance plug-to-plug
> is minimal (a couple of ohms) and resistance between
> pins is infinite so I can't account for the voltage
> difference relative to what the shop manual says.

> So what am I missing?  

A couple of ohms is a lot on a connector or a harness.
 I'd check to see what is causing it.  Sounds like you
may find the source of your trouble there.

=====
| Adam Wade                       1990 Kwak Zephyr 550 (Daphne) |
|   http://y42.photos.yahoo.com/bc/espresso_doppio/lst?.dir=/   |
| "It was like an emergency ward after a great catastrophe; it  |
|   didn't matter what race or class the victims belonged to.   |
|  They were all given the same miracle drug, which was coffee. |
|   The catastrophe in this case, of course, was that the sun   |
|     had come up again."                    -Kurt Vonnegut     |

__________________________________________________
Do you Yahoo!?
Y! Web Hosting - Let the expert host your web site
http://webhosting.yahoo.com/

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi