[Diy_efi] 2.0 diss module with the 1227749

Fri Sep 13 15:05:23 GMT 2002

--part1_195.cef066e.2ab163a4_boundary
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit

well here is my thought on this very subject and i will take any flames or 
compliments.as the diameter of the wheel decreases the speed of the trigger 
will go down at the outer most edge. even if the wheel were the right pattern 
this change in speed could drive the module nuts. think about it now the 
wheel is going solwer with a smaller trigger area. even properly scalled its 
still not what it had when it was first desinged. by changing the dimension 
of the wheel you could be inadverently scrweing with it. its actually apretty 
simple concept really a 36x drive cant read a cd rom disk spinning at 48x 
speeds can it ??

--part1_195.cef066e.2ab163a4_boundary
Content-Type: text/html; charset="US-ASCII"
Content-Transfer-Encoding: 7bit

<HTML><FONT FACE=arial,helvetica><FONT  SIZE=2>well here is my thought on this very subject and i will take any flames or compliments.as the diameter of the wheel decreases the speed of the trigger will go down at the outer most edge. even if the wheel were the right pattern this change in speed could drive the module nuts. think about it now the wheel is going solwer with a smaller trigger area. even properly scalled its still not what it had when it was first desinged. by changing the dimension of the wheel you could be inadverently scrweing with it. its actually apretty simple concept really a 36x drive cant read a cd rom disk spinning at 48x speeds can it ??</FONT></HTML>

--part1_195.cef066e.2ab163a4_boundary--

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi