[Diy_efi] pulling '98 motor

[mike beebe]

i would normaly lift them by the intake bolts. one on the drivers side front 
and one on the passenger rear. you could look for a couple of lift brakets 
off of other motors and put them under the bolts.



From: steve ravet <sravet at arm.com>
>Reply-To: diy_efi at diy-efi.org
>To: diy_efi <diy_efi at diy-efi.org>
>Subject: [Diy_efi] pulling '98 motor
>Date: Fri, 13 Sep 2002 16:35:16 -0500
>
>I'm going to yank the motor out of my '98 c1500 (350) this weekend.  I
>either need to look harder, or this engine doesn't have lifting rings
>attached anywhere.  Can it be lifted by the exhaust manifold?  With the
>trans attached?
>
>--steve
>
>--
>Steve Ravet
>steve.ravet at arm.com
>ARM,Inc.
>www.arm.com
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>http://www.diy-efi.org/mailman/listinfo/diy_efi




_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi