[Diy_efi] GM TPI fuel lines/rails and Saginaw fittings

[Shannen Durphey]

steve ravet wrote:
> 

> 
> This is the fuel line fitting from the '98 pickup I'm taking apart.  Is
> this a saginaw?
> 
> ftp://ftp.diy-efi.org/incoming/saginaw.jpg

Yep.
Shannen
> 
> Also, here is a picture of the high voltage switch (aka distributor)
> that it uses.  If you haven't seen it before, then like shannen said
> it's pretty neat because it routes the HV signal inside the body so that
> the even numbered plugs all attach to one side, and odd to the other.
> 
> ftp://ftp.diy-efi.org/incoming/high_voltage_switch.jpg
> 
> --steve
> 
> --
> Steve Ravet
> steve.ravet at arm.com
> ARM,Inc.
> www.arm.com
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi