[Diy_efi] Tapping Metric Injector Threads
Matt Porritt
porrittm at anet.co.nz
Tue Jan 7 05:40:40 GMT 2003
I presume you're tapping into alloy?
Try a smaller (slightly) drill.
I have references here in a Zeus book for 12 x 1.25 and 12 x 1.75 but not 12
x 1.50mm.. Hmmm..
Cutting fluid with tapping in alloy helps.
--
Matt Porritt
RC Race Cars and Supplies
ICQ #22776813
On 7/1/03 5:04 PM Brian Michalk wrote
> I've got a Bosch CIS injector, 0 437 502 047
> It has an M12x1.5 metric thread. That's 12mm major diameter with 1.5mm
> pitch.
>
> I bought a tap from MSC that I thought was supposed to be tapered. I tapped
> some scrap metal, and the injector screws into it with a very loose sloppy
> fit. I will try a smaller drill bit size, but I don't think that's going to
> help.
>
> Does anyone know if there exists such a tapered tap, like for NTP, except
> metric?
>
> If not, then I'll have to use O-rings.
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list