[Diy_efi] A Question

[Shannen Durphey]

The trans from the Camaro is not electronic, either.  The trans related
signals include the VSS and the TCC.  For retrofits people will usually
try to find an aftermarket electronic speed signal generator that will
install between the trans and the speedometer cable, or will try to
adapt a factory speed sensor from another year and/or model vehicle. 
You can run without a speed signal, but it's better to run with one as
several tables within the calibration are accessed based on speed
signal.

The tcc signal is much easier to work with.  Leave it disconnected.
Shannen

billmiranda at netscape.net wrote:
> 
> Hello,
> I'm new to the list and do not know if this has been covered in the past but:
> 
> I have a question about the ECM I receieved with an engine I purchased.  It's a 1989 L98 350 with TPI.  It came from an IROC-Z28 that had an automatic transmission.  I'm sticking this into my 1991 Toyota Landcruiser and the issue is that the Auto tranny in the Landcruiser is not Electronic in any way.  Is there a way or is there a prom I would need to purchase that would eliminate the need for a tranny signal going into the computer?
> 
> Thanks for any info from the list or for pointing me in the correct direction.
> 
> William Miranda
> 
> __________________________________________________________________
> The NEW Netscape 7.0 browser is now available. Upgrade now! http://channels.netscape.com/ns/browsers/download.jsp
> 
> Get your own FREE, personal Netscape Mail account today at http://webmail.netscape.com/
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi